1Z0-144 exam questions

This forum is for all kind of certifications & trainings related discussion.
Post Reply
qwrtfgyy
Posts: 4
Joined: Wed Sep 29, 2010 2:35 am
Location: United Kingdom

1Z0-144 exam questions

Post by qwrtfgyy »

1. Company uses layer 3 switches in the Core of their network. Which method of Layer 3 switching uses a
forwarding information base (FIB)?
A.Topology-based switching
B. Demand-based switching
C. Route caching
D. Flow-based switching
E. None of the other alternatives apply
Answer:A

2. You need to design the VLAN scheme for the Company network. Which two statements are true about
best practices in VLAN design? (Select two)
A. Routing should occur at the access layer ifvoice VLANs are utilized. Otherwise, routing should occur at
the distribution layer.
B. Routing should always be performed at the distribution layer.
C. VLANs should be localized to a switch.
D. VLANs should be localized to a single switch unlessvoice VLANs are being utilized.
E. Routing should not be performed between VLANs located on separate switches.
Answer: BC

3. Refer to the exhibit. On the basis of the information provided in the exhibit, which two sets of procedures
are best practices for Layer 2 and 3 failover alignment? (Choose two.)
A. Configure the D-SW1 switch as the active HSRProuter and the STP root for all VLANs.
Configure the D-SW2 switch as the standby HSRP router and backup STP root for all VLANs.
B. Configure the D-SW1 switch as the standby HSRP router and the STP root for VLANs 11 and 110.
Configure the D-SW2 switch as the standby HSRP router and the STP root for VLANs 12 and 120.
C. Configure the D-SW1 switch as the active HSRProuter and the STP root for VLANs 11 and 110.
Configure the D-SW2 switch as the active HSRP router and the STP root for VLANs 12 and 120.
D. Configure the D-SW2 switch as the active HSRProuter and the STP root for all VLANs.
Configure the D-SW1 switch as the standby HSRP router and backup STP root for all VLANs.
E. Configure the D-SW1 switch as the active HSRProuter and the backup STP root for VLANs 11 and 110.
Configure the D-SW2 switch as the active HSRP router and the backup STP root for VLANs 12 and 120.
F. Configure the D-SW1 switch as the standby HSRP router and the backup STP root for VLANs 12a nd
120.
Configure the D-SW2 switch as the standby HSRP router and the backup STProot for VLANs 11 and 110.
Answer: CF

4. If you needed to transport traffic coming from multiple VLANs (connected between switches), and your
CTO was insistent on using an open standard, which protocol would you use?
A. 802.11B
B. spanning-tree
C. 802.1Q
D. ISL
E. VTP
F. Q.921
Answer: C

5. Under what circumstances should an administrator prefer local VLANs over end-to-end VLANs?
A. Eighty percent of traffic on the network is destined for Internet sites.
B.There are common sets of traffic filtering requirements for workgroups located in multiple buildings.
C. Eighty percent of a workgroup's traffic is to the workgroup's own local server.
D. Users are grouped into VLANs independent of physical location.
E. None of the other alternatives apply
Answer:A

Many IT professionals prefer to add 1Z0-144 exam among their credentials.Test1pass is the online certification expert recognized by a worldwide audience of IT professionals and executives alike as the definitive source of training materials for the candidate seeking insight, updates and resources for vendor certifications.The certification strengthens the employment prospects and opens up myriads of opportunities for them.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest