Page 1 of 1
GL Account Security rule is not restricting entry
Posted: Mon Oct 26, 2009 12:46 pm
by kishorebhupati
Hi,
I have defined GL Security rule for range of Accounts and attached it to specific Responsibility, still when i am trying to enter JE though selecting the account it is allowing.
What steps probably i am missing in defining security rules.
Thanks
Bhupati
Posted: Mon Oct 26, 2009 2:51 pm
by tgs100
Check whether you have checked the 'Security Enabled' checkbox for the segment for which security rules are created.
navigation: Setup --> Financials --> Flexfields --> Key --> Segments --> Go to the flexfield structure and then Click Segments --> Go to the segments and click 'Open'.
Cheers,
Saravanan
Posted: Fri Oct 30, 2009 8:32 am
by Srinivas gurram
Before doing the security rules you must ensure the following options needs to be checked.
1."Security Enabled" at segment level which you created rules for the segment.
Steps: Setup>Financilas>Flexfileds,Key,Segments
place the cursor in segment which u defined the rules and click on open button.
2. Review valueset which u attched ur segment that u selected for rules and verify the security type is no security or non hierarchal securty or hierarchal security but should,nt be a no security
Setup> Financials>Flexfields>key>Validation>Sets
3. And verify ur security rules active or deactive
Please let me know if it is wrong any other reson is there.
Regards,
Srinivas